How Do I Finish A Container That Was Created After Changing The Measure Type From Quantity To Weight? : VetSnap

How Do I Finish A Container That Was Created After Changing The Measure Type From Quantity To Weight? Print

Created by: CSR2 Support

Modified on: Tue, 19 Aug, 2025 at 2:42 PM

After selecting Finish on a container, you'll be prompted to enter the final container weight.

If a discrepancy appears after entering the final weight, it’s due to a difference between the expected quantity and the actual weight, calculated using the mass-to-quantity conversion.

What should I do if there's a discrepancy?

You’ll need to adjust the container volume (mL) so that the remaining quantity shows as 0 before closing the container.
Discrepancies can occur due to factors like manufacturer overfill, even if the weight tracking has been accurate throughout the container’s use. It’s important to reconcile this difference before completing the process.

Privileged and confidential. For VetSnap approved use only. Copyright © VetSnap Corporation. All rights reserved. Not to be distributed, reproduced, modified, or used to create derivative works without explicit written permission from VetSnap Corporation. VetSnap is not a DEA consultant and does not provide legal or regulatory advice regarding controlled substances.

Csr2 is the author of this solution article.

Did you find it helpful? Yes No

How Do I Finish A Container That Was Created After Changing The Measure Type From Quantity To Weight? Print

What should I do if there's a discrepancy?

Related Articles